GBT OPERATIONS PROCEDURES

Number: INFO-06

Title: Listening Post Operator Console

Last Revision: 20 Nov 01

General

The listening post system is used to monitor sounds from various locations on the GBT. Unusual sounds can infer equipment malfunctions thus warning the operator of potential problems. The system consists of a monitoring console and speaker (located near the operator in the control room) and microphone sensors positioned at key telescope locations.  

Using the Listening Post Operator Console

STEP

ACTION

1

Select a location to monitor by toggling its switch to the down (ON) position. Multiple locations may be monitored at the same time, however this may mask some sounds. 

2

Adjust the speaker volume as necessary.

3

If using headphones, insert their plug into the labeled jack and adjust the volume as needed.

Console Layout

 

Specific Location of Microphone Sensors

Switch

GBT Location

L Band Frig

Receiver room with the specified receiver

C Band Frig

Receiver room with the specified receiver

Ku Band Frig

Receiver room with the specified receiver

S Band Frig

Receiver room with the specified receiver

K Band Frig

Receiver room with the specified receiver

Rx Rm Mic

Mounted in the receiver room

X Band Frig

Receiver room with the specified receiver

PF Rm (TeePee)

Inside the maintenance shelter located behind the receiver room turret

Sub-Reflec

On the cat walk above the sub reflector near the drive motors

PF Boom Motor

Near the cat walk where the PF boom extension motor is located 

PF Boom

On the prime focus boom receiver housing

Hoist B (VFA Elev)

On the cat walk near the level 4 hoist and upper elevator access point

Elev Bearing

On level 4 outside the shelter housing the elevation encoder

Actuator Room

Inside the actuator room on tipping structure

Elev Drv A

Railing mounted on the right (near) side of the elevation gear drive motors

Elev Drv B

Railing mounted on the left (far) side of the elevation gear drive motors

Servo Rm Mic

Servo room above and centered with the Interface cabinet

Motor Gens

Near phone box by the motor generator on level 1

Cryo Room

Next to entry door in the cryogenics pump room on level 1

Allidade Entran.

In front of the lower elevator door on level 1

Up Pntl Room

Inside the upper pintle bearing room  

Az Truck #1

In the center of the truck between the drives 

Az Truck #2

In the center of the truck between the drives

Az TRuck #3

In the center of the truck between the drives

Az Truck #4

In the center of the truck between the drives

Prepared by: Dave Rose, GBT Operator

Last modified: 20Nov01